Forum Replies Created

Viewing 1 post (of 1 total)
  • smart3d.net
    Participant
    2013-03-19 at 1:03 am
    Post count: 4
    in reply to: Slicing in Rhino 4, adding supports and printing #1046 |

    The best and easiest solution for Rhino is the Smart3d BAMBOO SupportGenerator:

    Automatc detection of growing points
    Automatic layout of supports in areas
    Pre-sets and editable supports
    direct interface with MiiCraft using the Smart3d SAMURAI for MiiCraft (solves boolean, self intersections, double surfaces during the slicing  …and it’s fast! )

    You can support and slice your parts in Rhino, and than immediately start the machine!

    http://www.smart3d.net/prototyping-machines/smart3d-miicraft

     

     

Viewing 1 post (of 1 total)