Hompage 討論群 MiiCraft+ Technical Supporting Structures Reply To: Supporting Structures

brupbacher
使用者
Post count: 20
#1041 |

hi pieralberto76, i am still struggeling with the microsoft side … mac works well.

the ‘not sticking’ issue:

– it also helps adding some scratches to the surface or sand it a little (the larger the surface the better)

– make sure the base plate is printed

– make sure the surface is clean (use alcohole to clean it, if you touched it with your finger it will not stick well …)

– make sure you keep the 7 seconds (i get perfect results with this)